Components Of The Kirk Wireless Server 300 Solution; Kirk Wireless Server 300; Wireless Bands; Table 2-1 Overview Of System Capacity - Polycom KIRK 300 Installation And Configuration Manual

Components of the KIRK Wireless Server 300 Solution

KIRK Wireless Server 300

Wireless Bands

In the following sections, you will find information about:
• "Components of the KIRK Wireless Server 300 Solution"
• "Requirements for the KIRK Wireless Server 300 Solution"
• "Installation Prerequisites"
The components of the KWS300 will be described below:
Below you will find an overview of the system capacity of the KWS300.
Table 2-1 Overview of System Capacity
Description
Max. number of simultaneous SIP calls
Max. number of repeaters
Max. number of registered handsets
The KWS300 controls the wireless infrastructure. It manages the repeater and
the IP interface to the call handler.
The communication protocol between the KWS300 and the call handler is SIP
A KWS300 is installed directly on the LAN and must be managed as part of the
corporate network.
For more information about the KWS300, refer to
Server 300" on page 3-1 and
page 4-1.
The wireless solution supports two wireless bands, allowing operation in
various countries and regions. Supported wireless bands are:
• ETSI (1880-1900 Mhz), referred to as 1G8
• USA DECT (1920-1930 Mhz), referred to as 1G9
Please note that it is not possible to change the predefined band.
Introduction to KIRK Wireless Server 300
on page 2-4
"Installing KIRK Wireless
"Configuring KIRK Wireless Server 300"
on page 2-2
on page 2-4
Capacity
4
6
12
on
2–2