Integral Abs Performing Bleed Test With Bmw Moditec; Final Inspection And Function Check; Final Cleaning - BMW R1150RT - MAINTENANCE INTEGRAL ABS Maintenance Manual

Table of Contents

Advertisement

Integral ABS Performing bleed test
with BMW MoDiTeC
d
Warning:
Self-diagnosis is not performed unless both brake
levers are in their fully released positions. Prior
to conclusion of the self-diagnosis, only RESIDUAL
BRAKING FUNCTION is available.
Perform BMW Integral ABS self-diagnosis:
Release the brake levers, if necessary.
Switch on the ignition.
With the ignition switched on, bed in the brake
pads against the brake discs.
ABS warning light.............................flashes at 4 Hz
General warning light ........................................ ON
Self-diagnosis is in progress
ABS warning light.............................flashes at 1 Hz
General warning light ....................................... OFF
Self-diagnosis successfully completed.
Perform bleed test with BMW MoDiTeC:
Remove front and rear seats.
Connect the BMW MoDiTeC to the diagnosis
connector.
d
Warning:
When performing maintenance and repair work on
BMW Integral ABS, never pump quickly or vigorous-
ly.
Perform bleed test.
Perform all requisite repair work.
Perform BMW Integral ABS pull-away test:
When a speed of 5 km/h (3 mph) is reached, the
ABS warning light must go out.
L
Note:
The ABS warning light and the general warning light
must both be OFF after successful self-diagnosis
and the pull-away test.

Final inspection and function check

Clutch
Check gear shift action.
Handbrake and foot brake
Check lights and signalling equipment:
Front and rear parking lights
Instrument lighting
Low and high headlight beams, headlight flasher
Fog lamps
Brake light (operate brake at front and rear)
Turn signals left/right
Hazard warning lights
Horn
Telltale and warning lights
Instruments
Check operation of optional extras.
If necessary, take the motorcycle for a test ride.
Confirm pre-delivery check in Service and Tech-
nical Booklet.
See "Checking motorcycle for damage" if defects
are found.

Final cleaning

Clean the motorcycle.
L
Note:
Do not use a steam or high-pressure water jet. The
high steam or water pressure could damage seals,
the hydraulic system or electrical components.
00.23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 1150 rt

Table of Contents