51
Removing and installing ignition
switch/steering lock
1
•
Remove fork bridge.
•
With a 4 mm (0.16 in) dia. drill bit, drill approx.
5 mm (0.20 in) into non-removable screw (1).
•
Use an 8 mm (0.31 in) dia. drill bit to drill away the
screw head.
•
Pull out the ignition switch/steering lock.
•
Unscrew and remove remainder of screw with
stud bolt extractor.
•
Install steering lock with non-removable socket
wrench insert, BMW No. 51 0 531.
X
Tightening torques:
Non-removable screws
(microencapsulated) ..................................... 15 Nm
Removing and installing ignition/light
switch
2
•
Remove socket head cap screw (2).
Removing and installing lock barrel
1
RS510010
•
Key in ON position/press in keeper (1) with a stiff
wire or similar.
•
Pull out lock barrel with key.
•
Lubricate the new lock barrel with
Shell Retinax A.
•
Insert the lock barrel with the key in the ON
position.
•
Press lock barrel down until keeper engages.
Drilling out lock barrel
•
Use a 4-5 mm (0.16-0.20 in) dia. drill bit to drill
the full length of the lock barrel.
•
Repeat with a drill bit of larger diameter until the
lock barrel can be removed.
Removing and installing dualseat
lock
S510010
•
Remove seat.
•
Remove dualseat lock
•
Press in keeper (arrow) with a length of wire or
similar.
•
Pull out lock barrel with key.
•
Lubricate the new lock barrel with
Shell Retinax A.
•
Press lock barrel in until keeper engages.
S510020
S510030
51.3