Removing/Installing Ignition Switch/Steering Lock Cable - BMW k 1200 rs Repair Manual

Removing/installing ignition
61 31
switch/steering lock cable
– Remove the right side section of the fairing
( 46.8).
a
1
•
Carefully remove the sealing lacquer from the
tapped hole for grub screw (1).
•
Remove the grub screw.
•
Pull the ignition/light switch housing (2) with ca-
ble off downwards.
•
Release the cable tie (arrow).
61.18
•
Open the lid of the electronic equipment box.
•
Disconnect plug (arrow).
2
•
Installation is the reverse of the removal proce-
KR610340
dure. Pay particular attention to the following:
L
Note:
Seal the tapped hole for grub screw (1) with lacquer.
When installing, note correct position of cable ties.
KR610100
KR610110
KR610130