Installing Input Bevel Pinion - BMW R 1100 S Repair Manual

120 h

Installing input bevel pinion

00 5 500
33 1 760
•
Lightly oil the sealing ring at the sealing lip and
round the outer edge.
•
Press/drive sealing ring (1) with drift,
BMW No. 33 1 760, and handle,
BMW No. 00 5 500, into threaded ring (2).
•
Stand housing with drive-side protrusion upright
and heat to 120 °C (248 °F).
•
Working from above, insert input bevel pinion (3)
complete with spacer (4).
L
Note:
If necessary, chill input bevel pinion prior to installa-
tion in refrigerator/freezer, or similar.
•
Insert outer race (5).
5
7
4
•
Coat threaded ring (6) with Hylomar SQ 32 M.
•
Tighten threaded ring with pin wrench,
BMW No. 33 1 700.
•
Install thrust ring (7).
L
Note:
Make sure that the lip of the shaft seal is seated cor-
rectly on the thrust ring.
•
Tighten hex nut (8) with w/f 36 socket wrench in-
sert and reduction adapter, BMW No. 33 1 720.
1 e
Caution:
Make sure that the nut does not damage the shaft
sealing ring.
2
X
Tightening torques:
S330070
Threaded ring
(thread cleaned + Hylomar SQ 32 M) ........ 118 Nm
Nut for input bevel pinion
(thread cleaned + Loctite 2701).................. 200 Nm
6
33 1 720
8
3
33 1 700
S330060
33.9