Disassembling Input Bevel Pinion - BMW R 1150 RT Repair Manual

33 1 510
•
Position rear wheel drive upright with retaining
fixture, BMW No. 33 1 510.
e
Attention:
To prevent the input bevel pinion from being dam-
aged when it falls out, use a soft underlay.
•
Heat the housing until the input bevel pinion is
released (max. 120 °C/248 °C) and drops out.
•
Remove the input bevel pinion and the spacer.
33.8

Disassembling input bevel pinion

33 12
120 h
R21330010
•
Remove outer bearing race (1).
•
Clamp input bevel pinion (2) into vise with protec-
tive jaws (splines facing upwards).
00 7 500
•
Using puller, BMW No. 00 7 500, pull off both
bearings at the same time.
•
Remove thrust ring (3).
•
Remove ball thrust bearing (4), inner race (5), roll-
er bearing cage (6) and outer race (7).
5
7
6
2
R21330090
KR330100
4
1
3