Removing, Dismantling, Reassembling And Installing Rear Wheel Drive; Removing Rear Wheel Drive; Removing Input Bevel Pinion - BMW R 1200 C Repair Manual

2
Removing, dismantling,
reassembling and installing rear
wheel drive

Removing rear wheel drive

•
Raise the motorcycle with the auxiliary stand,
BMW No. 00 1 550.
•
Drain the oil.
•
Detach the brake caliper and secure it to the rear
frame with a cable strap.
•
Remove sensor (1) for the speedometer signal.
•
Remove ABS sensor (2).
•
Remove rear wheel.
•
Heat the brake disc retaining screws to 120 °C
(248 °F).
L
Note:
Mark the position of the brake disc.
The sensor gap setting remains unchanged.
•
Detach the rear wheel drive and pull it off the
drive shaft.
1

Removing input bevel pinion

•
Press out splined section of shaft.
•
If necessary, remove/install circlip.
120 h
C330011
C330090
33.5