Technical Data; Technical Data - Servo Drives - Siemens SINAMICS V90 Operating Instructions Manual

2.7

Technical data

2.7.1

Technical data - servo drives

General technical data
Parameter
24 VDC Voltage (V)
power
Maximum current (A)
supply
Overload capability
Control system
Dynamic brake
Protective functions
Speed Speed control range
control
Analog speed command input
mode
Torque limit
Position Max. input pulse frequency
control
Command pulse multiplying
mode
factor
In-position range setting
Error excessive
Torque limit
Torque Analog torque command input
control
Speed limit
mode
Environ- Surrounding air
mental temperature
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E36037884-002
Description
24 (-15% to +20%)
1.6 A (when using a motor without a brake)
3.6 A (when using a motor with a brake)
300%
Servo control
Built-in
Earthing fault protection, output short-circuit protection
age/undervoltage protection
protection
4)
Analog speed command 1:2000, internal speed command 1:5000
-10 VDC to +10 VDC/rated speed
Set through a parameter or the analog input command (0 VDC to +10
VDC/max. torque)
1 M (differential input), 200 kpps (open collector input)
Electronic gear ratio (A/B)
A: 1 - 10000, B: 1 - 10000
1/50 <A/B < 200
0 to ±10000 pulse (command pulse unit)
±1/10 revolutions
Set through a parameter or the analog input command (0 VDC to +10
VDC/max. torque)
-10 VDC to +10 VDC/max. torque (input impedance 10 kΩ to 12 kΩ)
Set through a parameter or the analog input command (0 VDC to +10
VDC/max. rated speed)
Operation 0 °C to 45 °C: without power derating
45 °C to 55 °C: with power derating
1)
, I t inverter,I t motor, IGBT overtemperature
3) 2 2
General information
2.7 Technical data
, overvolt-
2)
47