Transferring Data (Sd To Drive) - Siemens SINAMICS V90 Operating Instructions Manual

Note
Plugging or unplugging the micro SD card/SD card will cause transferring failure.
Do not plug or unplug the micro SD card/SD card during transferring; otherwise, the
transferring operation will fail.
Note
Write protection function is not supported by SINAMICS V90. Data in the micro SD card/SD
card will be overwritten even if the write protection function of the micro SD card/SD card is
enabled.
6.5.5

Transferring data (SD to drive)

You can also upload the parameters from a micro SD card/SD card to the drive ROM. To do
this, proceed as follows:
Note
Data transfer between the drive and the SD card is possible only when the drive is in
"S OFF" state.
Note
Plugging or unplugging the micro SD card/SD card will cause transferring failure.
Do not plug or unplug the micro SD card/SD card during transferring; otherwise, the
transferring operation will fail.
Note
Parameter inconsistency
If the parameters on the micro SD card/SD card are inconsistent with existing parameters in
the drive memory, you must restart the servo drive to apply the changes.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E36037884-002
Basic operator panel (BOP)
6.5 Auxiliary functions
155