Parameters; Overview - Siemens SINAMICS V90 Operating Instructions Manual

Parameters

10.1

Overview

The section below lists all the parameters of the SINAMICS V90 servo drive.
Parameter number
Numbers prefixed with an "r" indicate that parameter is a read-only parameter.
Numbers prefixed with a "P" indicate that the parameter is an editable parameter.
Effective
This indicates the conditions for making parameterization effective. Two conditions are
possible:
● IM (Immediately): Parameter value becomes effective immediately after changing.
● RE (Reset): Parameter value becomes effective after repower-on.
Can be changed
This indicates when the parameter can be changed. Two states are possible:
● U (Run): Can be changed in the "Running" state when the drive is in "S ON" state. The
"RDY" LED lights up green.
● T (Ready to run): Can be changed in the "Ready" state when the drive is in "S OFF" state.
The "RDY" LED lights up red.
Note
When judging the state of the drive according to the "RDY" LED, ensure that no faults or
alarms exist.
Data type
Date type
Integer16
Integer32
Unsigned8
Unsigned16
Unsigned32
FloatingPoint32
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E36037884-002
Abbreviation
I16
I32
U8
U16
U32
Float
10
Description
16-bit integer
32-bit integer
8-bit unsigned integer
16-bit unsigned integer
32-bit unsigned integer
32-bit floating point number
285