Clutch Switch - MOTO GUZZI 2Q000297 Service Station Manual

Electrical system
Start up
Start-up enabling switches
Position
•
on the vehicle: under the tank, near the
battery
•
connector: on the control unit from 34
PIN
Pin-out
1. Left coil control (1)
2. Right lambda probe heater signal (2)
3. Neutral gear switch control inlet (neutral)
4. Run-off control input
5. Start button inlet
6. Key-on positive
7. Ground 1 (-)
8. Right coil control (2)
9. Battery positive 12V
10.Starter motor relay control
11.Left lambda probe positive signal (1)
12.Left (1) and right (2) lambda probe negative
signal
13.Temperature signal sensor
14.Clutch switch signal
15.External sensor ground
16.K diagnostic line
17./
18.Right lambda probe positive signal (2)
19.Hanger switch and fall sensor inlet
20.Engine revolution sensor negative signal
(pick up)
21.Sensors power supply
22.Injection relay control
23.Ground 2 (power)
24.Secondary air system control
25./
26.CAN H line
27.CAN L line
ELE SYS - 140
V7 III ABS