MOTO GUZZI 2Q000297 Service Station Manual page 45

V7 III ABS
Check
•
Keep the vehicle upright with both
wheels on the ground.
•
Unscrew and remove the cap/dipstick
(1).
•
The level is correct if the oil is close to
the cap/dipstick opening (1).
•
If the oil is lower than specified, top-up
until it reaches the cap/dipstick hole
(1).
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO
THE FLUID. WHEN USING A FUNNEL OR ANY OTHER EL-
EMENT, MAKE SURE IT IS PERFECTLY CLEAN.
Replacement
CAUTION
THE UNIT MUST BE HOT WHEN THE OIL IS CHANGED AS UNDER SUCH CONDITIONS OIL IS
FLUID AND THEREFORE EASY TO DRAIN.
NOTE
RIDE SOME km (miles) TO WARM UP ENGINE OIL
•
Place a container with + 400 cm³ (25 cu in) capacity under the drainage plug (3).
•
Unscrew and remove the drainage plug (3).
•
Unscrew and remove the breather cap (2).
•
Drain the oil into the container; allow several minutes for oil to drain out completely.
•
Check and if necessary, replace the sealing washer of drainage plug (3).
•
Remove any metal scrap attached to the drainage plug (3) magnet.
•
Screw and tighten the drainage plug (3).
•
Pour new oil through the fill opening (1) until it reaches the cap/dipstick hole (1).
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO THE FLUID. WHEN USING A FUNNEL
OR ANY OTHER ELEMENT, MAKE SURE IT IS PERFECTLY CLEAN.
Maintenance
MAIN - 45