Suspensions
•
Unscrew the lower ring nut in order to
repeat the steering play adjustment
procedure correctly.
•
Pre-tighten the lower ring nut to the torque of 60 Nm (44.25 lb ft).
•
Steer repeatedly completely left and completely right to allow the bearings to settle.
•
Loosen the ring nut.
•
Check again the pre-tightening torque and then tighten the ring nut again to a torque of 50
+/- 5 Nm (36.88 +/- 3.69 lb ft).
•
Steer completely left and completely right and check that the steering rotates smoothly and
without excessive resistance.
•
If any problems are noted, repeat the procedures described above.
Specific tooling
AP8140190 Tool for steering tightening
•
Reposition the rubber spacer (3)
•
Insert and tighten the steering counter-lock ring (2) so that the grooves are aligned
•
Reposition the safety washer (1)
•
Refit the upper steering plate, handlebars and instrument cluster
Rear
SUSP - 190
V7 III ABS