MOTO GUZZI 2Q000297 Service Station Manual page 189

V7 III ABS
Pos. Description
6 Connector plate fastening screw
7 Screws fastening stanchion on lower plate
8 Pumping unit fastening screw
Adjusting play
•
Place the vehicle so that the front wheel is off the ground.
•
Carry out a handlebar rotation test, using a dynamometer at the hand grip external end.
•
Adjust if clearance is detected.
NOTE
THE STEERING COLUMN RESISTANCE TO ROTATION MUST BE PERFORMED IN THE TWO
OPPOSITE ROTATION DIRECTIONS.
•
Remove temporarily, moving the in-
strument cluster, handlebars (com-
plete with column switch and brake and
clutch levers) and the upper steering
plate towards the front of the vehicle
•
Remove the safety washer (1)
•
Remove the steering counter-lock ring
(2) using the special tool
•
Remove the rubber spacer (3)
Type Quantity Torque
M6x16 1 10 Nm (7.38 lb ft)
M10 2 45 Nm (33.19 lb ft)
M10 2 50 Nm (36.88 lb ft)
Suspensions
Notes
-
-
-
SUSP - 189