MOTO GUZZI 2Q000297 Service Station Manual page 201

V7 III ABS
•
Working from the LH side, remove the
LH spacer;
NOTE
DURING REFITTING, PAY ATTENTION TO THE CORRECT
POSITIONING OF THE SPACER WHICH MUST BE INSER-
TED IN THE DUST SEAL UNTIL IT REACHES THE BEAR-
ING
•
Remove and if necessary replace the
six flexible couplings
•
Remove the dust seal
•
Using a generic bearing extractor re-
move the bearings from both sides
Spoke tension adjustment
CAUTION
DO NOT ADJUST THE TENSION OF THE WHEEL SPOKES WITH TIRES FITTED ON THE WHEEL
RIM, AS THIS COULD CAUSE BREAKING OF THE NIPPLE GUARDS AND RESULTING IN HOLES
OF THE AIR CHAMBER.
IT IS IMPORTANT TO LOCK THE ROTATION OF ALL NIPPLES.
LOOSENING THE NIPPLE MODIFIES THE TENSION OF THE WHEEL SPOKES COMPROMISING
THE SAFETY OF THE WHEEL RIMS AND THE STABILITY OF THE VEHICLE
•
Remove the wheel
•
Remove the tires, the air chamber and the nipple guards;
•
Locate the wheel spokes (1) to be tightened;
•
Operate on the nipple (2) to adjust the relative spoke tension (1);
- screw to tighten the spoke;
Chassis
CHAS - 201