V7 III ABS
•
Check the coils connection (and their correct positioning on the frame)
•
Check that the engine oil cap has been inserted correctly
•
Check ground fastening on the engine
•
Check NEUTRAL cable fastening
•
Check whether the right lambda probe is connected to the output labelled "LAMBDA DX" (RH
LAMBDA)
•
Check the Regulator and Flywheel connection
•
Check whether the right and left lambda probe cable is inserted on the cable grommet under
the clutch housing
•
Check the right Lambda connections
•
Check the Pick Up connection
•
Check correct insertion of the starter motor hood and engine start faston
•
Check the presence of the Red protective hood on the battery Positive
•
Check that the stand switch connector is blue and clamped
•
Check the side stand connection and the left lambda
•
Check the rear stop connection
•
Check the stand switch cable ties on the frame under the vehicle
•
Check the assembly of the fall sensor (if the arrow is upwards and the connector is grey)
•
Check the connection of the secondary air valve and the correct positioning of the cap
•
Check the connection of the front stop faston.
CAUTION
THE ENCIRCLED CONNECTORS ARE CONSIDERED CRITICAL IN COMPARISON WITH ANY
OTHER BECAUSE THE VEHICLE WILL STOP OR PRESENT A MALFUNCTION IF THEY ARE AC-
CIDENTALLY DISCONNECTED.
Undoubtedly the connection of the rest of connectors is also important and essential for the
correct operation of the vehicle. It is also important and essential that the instructions regarding
the routing and fixing of the wiring harness in the various areas are followed meticulously in
order to guarantee functionality and reliability
COMPONENTS PRE-FITTING
TABLE A - ENGINE
•
Check that the HV cable of the left cyl-
inder has grey taping
TABLE B - REAR COIL ON THE FRAME
Electrical system
ELE SYS - 75