MOTO GUZZI 2Q000297 Service Station Manual page 183

V7 III ABS
•
Slide the dust scraper off and upwards.
•
Remove the locking ring inside the fork
leg using a thin screwdriver.
CAUTION
BE CAREFUL NOT TO DAMAGE THE FORK LEG RIM.
•
Slide off the bearing tube from the
wheel holder fork leg together with the
sealing ring, the cap, the upper bush-
ing and lower bushings.
NOTE
WHEN REMOVING THE PIPE FROM THE WHEEL HOLDER
FORK LEG SOME PARTS MAY REMAIN INSIDE THE FORK
LEG. IF THIS OCCURS, THESE PARTS MUST BE RE-
MOVED AFTERWARDS, BEING CAREFUL NOT TO DAM-
AGE THE FORK LEG RIM AND THE UPPER BUSHING
SEAT
Checking the components
•
Check every component removed from
the fork leg, specially: the sealing ring
and the dust guard as they are ele-
ments that guarantee sealing; replace
them if some of them are damaged.
•
Check the bushing on the bearing tube;
remove it and replace it if damaged or
worn.
•
Slide off the pumping member unit
from the holding tube; if it is damaged,
replace the counter spring and the ring.
Suspensions
SUSP - 183