Electrical system
•
1 Black sheath
•
7 ABS Cable grommets
•
1 connector clip
Motorcycle division
The wiring timing is subdivided in three essential
sections, as indicated in the figure.
1. Front section
2. Central section
3. Rear section
SPECIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES
It is extremely important that any security-locks for the following connectors are properly con-
nected and correctly tightened to ensure proper engine, and therefore proper vehicle, operation.
Carry out the checks listed below.
•
Instrument panel connector (is engaged and the boot well inserted)
•
Rear and front wheel ABS sensor connector
•
Check the correct routing of the rear turn indicators cables on the license plate holder (RH
and LH)
•
Check the correct closing of the ABS ECU and the correct routing of the branch on the
conduit
•
Taillight connector
•
Right and Left light switch connectors
•
Clutch connector
•
Connector ignition switch connector (check that the cable is not live)
•
Immobilizer antenna connector
•
ECU connector (G3) and the correct insertion of the relative rubber plug
•
Check the correct fastening of metallic bracket screw on the throttle body
•
Check the fastening of the positive Battery cable on the starter motor. Check that the cap is
well inserted
•
Check the insertion of the starter motor faston
•
Check the correct passage and fixing of the ABS fuse
•
Check the right and left injectors connection
•
Check the connection of the engine head temperature sensor
•
Check the correct insertion of H.V. Cables with the Coils (RH and LH)
•
Check whether the Grey H.V. Cable connects on the Coil with the Grey tape
•
Check whether the Grey H.V. Cable goes to the Left engine head
ELE SYS - 74
V7 III ABS