MOTO GUZZI 2Q000297 Service Station Manual page 156

Engine from vehicle
Pos. Description
1 Screws fastening the tank support
buffers to the frame
2 Front cradle fixing screws
3 Screw fastening the stand cross-
piece to the cradles
4 Rear plate fastening screw
5 Screws fastening engine/gearbox to
frame
6 Screws fastening gearbox to frame
7 Rear grab handle fastening screws
Vehicle preparation
•
To arrange for the removal of the engine block, you must first remove the saddle, fuel tank,
side fairings and the battery
•
From the front, secure the vehicle with belts attached to a hoist
•
Position a centre stand under the engine sump
•
Position an engine support so as not to damage the rubber bellows of the drive shaft
ENG VE - 156
C
HASSIS
Type Quantity
M8 2 25 Nm (18.44 lb ft)
M10 4 50 Nm (36.88 lb ft)
M10 1 50 Nm (36.88 lb ft)
M8 4 35 Nm (25.81 lb ft)
M10 3 50 Nm (36.88 lb ft)
M10 2 50 Nm (36.88 lb ft)
M6 2 10 Nm (7.38 lb ft)
V7 III ABS
Torque Notes
-
-
Pre-permeated
Pre-permeated
-
-
-