MOTO GUZZI 2Q000297 Service Station Manual page 278

Bodywork
•
Disconnect the connector from the
headlamp and remove it
BULB REPLACEMENT
•
To replace the bulbs, remove the com-
plete parabole from the headlight body
by undoing the screw (1)
LOW BEAM / HIGH BEAM LIGHT BULB
•
Pull out the electrical connection to the bulb (2), and disconnect it from the bulb.
•
Move hood (3) manually.
•
Release the two ends of the retaining spring (4) located on the bulb holder.
•
Pull the bulb (5) out of its fitting.
NOTE
INSERT THE BULB INTO THE BULB HOLDER, MAKING SURE THE REFERENCE FITTINGS
MATCH.
TAIL LIGHT BULB
•
Pull out the daylight running light bulb holder (6) from its seat.
•
Remove the bulb (7) and replace it with another of the same type.
•
Check the proper insertion of the bulb in the bulb holder.
BODYW - 278
V7 III ABS