MOTO GUZZI 2Q000297 Service Station Manual page 123

V7 III ABS
•
Heater circuit: 12 -14 Ω at 20 °C (68 °
F)
Pin-out
1. Positive sensor signal (pink)
2. Negative signal sensor (green/white)
3. Heater ground (violet/white)
4. Heater power (red/brown cable)
Diagnostic tool - Parameters and statuses
•
Oxygen sensor voltage LH - (mV)
•
Left lambda probe - (---, Not enabled,
Not active (start), Not active (heat.),
Not active (rich), Operating, Not active
(lean), Fault
Diagnostic tool - Activation
•
Lambda probe heater 1
Diagnostic tool - Electrical errors
Control of the air-fuel ratio / Left lambda probe P0130 - positive short circuit / open circuit, short
circuit to negative / signal not valid.
Error cause
•
Short-circuit to positive: excessive voltage to PIN 11 or PIN 12 of the control unit connector
•
Open circuit or short-circuit to negative: interruption of the circuit or null voltage between
control unit connector PIN 11 and 12
Troubleshooting
Short-circuit to positive:
•
Disconnect the control unit connector and the sensor connector.
•
Verify that there is no short to battery positive on sensor connector PIN 1 (corresponding to
control unit connector PIN 11); if there is a short, restore the wiring harness.
•
Verify that there is no short to battery positive on sensor connector PIN 2 (corresponding to
control unit connector PIN 12); if there is a short, restore the wiring harness.
Open circuit:
•
Disconnect the control unit connector and the sensor connector.
•
Verify continuity of the wiring harness between the sensor connector and the control unit
connector: Control unit PIN 11 - sensor PIN 1 and control unit PIN 12 - sensor PIN 2. If
necessary, restore the wiring harness.
•
If the wiring harness is intact and the error persists, proceed with the following checks.
Short-circuit to negative:
Electrical system
ELE SYS - 123