MOTO GUZZI 2Q000297 Service Station Manual page 73

V7 III ABS
5. Taillight
6. MIU G3 Control Unit
7. Engine speed sensor
8. Starter motor
9. Engine speed sensor
10.Fuses
11.Battery
12.Head temperature sensor
13.Instrument panel air sensor
14.Headlamp
15.Voltage regulator
16.Alternator
17.Oil pressure sensor
18.Lambda probes
Electrical system installation
INTRODUCTION
Scope and applicability
The position of the wiring harnesses, how they are fixed to the motorcycle and potential problems are
defined on the following sections in order to reach the objectives of vehicle reliability.
Materials used and corresponding quantities
The electrical system consists of the following wiring harnesses and parts:
•
1 Vehicle wiring harness
•
1 Headlamp wiring harness
•
2 ABS speed sensor
•
1 Horn
•
2 Lambda probe
•
1 Stand switch
•
1 Fall sensor (grey connector)
Small parts and mountings
•
11 Large black 290x4 clamps
•
4 Small black 160x2.5 clamps
•
1 Small cable guide rubber clamp
•
2 Large cable guide rubber clamps
•
1 ECU bracket
•
2 Connector supports
•
1 Cable grommet
Electrical system
ELE SYS - 73