V7 III ABS
•
Unscrew and remove the three head
cover retaining screws (6)
•
Remove the head cover (7)
•
Unscrew the spark plug (8) and re-
move it
REMOVE THE RIGHT HAND CYLINDER
SPARK PLUG TOO SO THAT IT IS POSSIBLE
TO TURN THE ENGINE OVER MANUALLY, EN-
GAGE FIRST GEAR AND ROTATE THE REAR
WHEEL
•
Stop rotating when the top dead centre
point is reached and check that there
is enough clearance on the rockers to
perform the measurement
•
Use a feeler gauge to check that the
clearance between the valve and the
set screw corresponds with the indica-
ted values. The corresponding intake
and outlet valve clearances are differ-
ent than what is indicated below, pro-
ceed with adjusting them.
Characteristic
Intake valve clearance
Maintenance
MAIN - 59