V7 III ABS
Clutch lever sensor
Function
Indicates the clutch lever position to the control
unit
Operation / Operating principle
In order to start the engine, pull the clutch also with
the gear in neutral
Level in electrical circuit diagram
Start enable.
Position
•
sensor: under clutch lever
•
Connector: under the fuel tank on right
side
Electrical specifications
•
Clutch pulled: closed circuit (continui-
ty)
•
Clutch released: open circuit (infinite
resistance)
Pin-out
1. 12 V Voltage (brown/white)
2. Ground (blue/green)
Diagnostic tool - Parameters and statuses
•
Clutch - (Pulled, Released)
Diagnosis
Even with the clutch lever pulled, the vehicle does not start
Error cause
•
Possible malfunction
Troubleshooting
•
Verify that, if a gear is engaged, the stand is up.
•
If it is up, check continuity of the brown/white cable and control unit PIN 14.
•
If there is no continuity, restore the wiring harness.
•
If there is continuity, disconnect the sensor and, with the clutch pulled, check for continuity
between the two sensor PINs.
•
If absent, replace the sensor.
Electrical system
ELE SYS - 133