V7 III ABS
TABLE D2
•
When the connector is fully inserted,
the distance between the connector
and the ABS control unit must be 7.5
mm (0.29 in)
TABLE D3
•
If the initial position of the connector
and driving lever is not as the one
shown in "TABLE D". The connector
will not be coupled correctly and the
measured distance will by greater, ap-
proximately 12 mm (0.47 in). In this
case, repeat the operations according
to the instructions in "TABLES D1/D2".
It is recommended to create a template
to check the correct insertion of the
connector.
TABLE D4
•
Check that the ABS control unit con-
nector cap is well inserted and that the
cable does not touch the frame
Electrical system
ELE SYS - 85