Electrical system
Azzeramento icona manutenzione
The system displays the function as follows:
•
when a maintenance interval threshold
is exceeded, an icon with a spanner is
shown on the LCD display.
To reset Service proceed as follows:
•
Connect the diagnostic tool
•
Select the concerned model and inside
the section "SELF-DIAGNOSIS" enter
the menu "ACTIVATIONS"
•
Activate the control "SERVICE RE-
SET"
Battery recharge circuit
RECHARGING SYSTEM
•
Slightly lift the fuel tank, being careful
not to pull the pipes with the relative
hooks;
•
Remove the connectors from the com-
partment behind the steering column
•
Disconnect the three-way connector
(1) (white).
NOTE
THE ENGINE SIDE IS IDENTIFIED WITH THE LETTER "A"
Measurement of resistance (with engine off)
•
For a correct detection of the alternator
resistance, must be performed an am-
bient temperature measurement and
then a further heat stabilisation with a
tester.
ELE SYS - 106
V7 III ABS