Chassis
For coupling, proceed as follows:
•
Provisionally lock the complete pinion
case on the housing with two nuts and
appropriate spacers.
•
Fit the corresponding tool on the crown
(19928800).
•
Insert the tool on the bearing cage in
the housing.
•
Check alignment between pinion teeth
and the crown teeth.
•
If alignment is not regular, properly
vary the thickness of the ring between
the pinion and the tapered bearing.
•
Also check the contact area between
the pinion teeth and the crown teeth,
proceeding as follows:
•
Apply suitable colours available in the
market on the pinion teeth.
•
Install the same type of gaskets present during the removal, the composition paper/steel/
paper or foamet/steel/foamet
CHAS - 216
V7 III ABS