V7 III ABS
The difference between 'MAX' and 'MIN' marks is
approx. 400 cm³ (24.41 cu.in)
•
The oil level is correct when it is close
to the 'MAX' mark.
Add engine oil if required:
•
Unscrew and remove the filler plug/oil dipstick.
•
Top up using engine oil until it reaches the correct level.
CAUTION
DO NOT GO BEYOND THE "MAX" AND BELOW THE "MIN" LEVEL MARK TO AVOID SEVERE
ENGINE DAMAGE.
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO THE FLUID. WHEN USING A FUNNEL
OR ANY OTHER ELEMENT, MAKE SURE IT IS PERFECTLY CLEAN.
Replacement
•
Place a recipient with a capacity of at
least 2,000 cm³ (122.05 cu.in) under
the drain plug (1).
•
Unscrew and remove the drainage
plug (1).
•
Unscrew and remove the filler plug (2)
•
Drain the oil into the container; allow
several minutes for oil to drain out com-
pletely.
•
Check and if necessary, replace the
sealing washer of drainage plug (1).
•
Remove any metal deposits attached
to the drainage plug (1) magnet.
•
Screw and tighten the drainage plug
(1).
Tightening torque for drainage plugs (1): 20 -
22 Nm (14.75 - 16.23 lb ft).
Maintenance
MAIN - 47