MOTO GUZZI 2Q000297 Service Station Manual page 136

Electrical system
2. Ground (blue/green)
3. Power supply (grey/green)
4. Signal/consent (grey/sky blue)
Diagnostic tool - Parameters and statuses
•
Tipping sensor - (Engine inhibited,
Gear allowed, YES, Lean, Rich, Rich
title, Error, Lean title)
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
Diagnosis
The engine stop button is in "ON" but its status remains in "OFF"
Error cause
•
Possible malfunction caused by the fall sensor or RUN-STOP switch
Troubleshooting
•
See diagnosis "RUN-STOP switch", if not ok check the correct status of the fall sensor
SAS valve actuator
Function
Improves the reaction of oxide, reduction after
combustion
Operation / Operating principle
The valve coil is excited to open the air passage
of the filter box to the exhaust manifold
Level in electrical circuit diagram
Secondary air valve
Position:
•
on the vehicle: under the fuel tank, in
the middle of the "V" of the engine, at-
tached to the chassis
•
connector: on the valve
Electrical specifications
•
Resistance at ambient temperature: 21
+3/- 1 Ω
Pin-out
ELE SYS - 136
V7 III ABS