Tektronix WFM5200 User Manual page 111

WFM5200 Waveform Monitor User Manual
enter only an IP address if you are using an Ethernet cable to connect
the PC directly to the instrument.
NOTE.
If you selected DHCP mode, the network automatically assigns the
instrument an IP address.
e. Press the CONFIG button on the front panel to close the menus.
4. Prepare the instrument for the software upgrade:
a. Press the CONFIG front panel button.
b. Navigate to Utilities > System Upgrade > Upgrade Options > Network
Upgrade.
c. Press the SEL front panel button. This displays the System Software
Upgrade window.
5. Perform the software upgrade:
a. On the PC, double-click the transfer.exe file to launch the transfer
program.
b. Type the IP address or DNS name of the instrument you are upgrading,
and then press Enter. This starts the software upgrade process.
CAUTION.
To prevent upgrade failure, do not close the transfer.exe window
until the transfer utility asks for another IP address.
When the software upgrade completes, the instrument may reboot.
c. The transfer utility displays done when the software upgrade completes.
When the software upgrade completes, the instrument will reboot.
Functions
95