Installing the Rack
Installing the tilting protection at the rear
At the rear, the tilting protection is attached with a fixing plate.
●
Attach the fixing plate to the slider with two supplied M6 x10 mm countersunk screws
●
(1) .
Torque: 5.2 Nm
Lift the tilting protection slightly so that the screw holes align with the lozenge nuts.
●
Attach the tilting protection to the rear of the rack with two supplied M6x10 mm
●
countersunk screws (2).
Torque: 5.2 Nm
Using the tilting protection
Extracting the tilting protection
U41840-J-Z125-7-76
2
2
1
1
Handling Instructions for the Rack
91