Fujitsu ETERNUS CS800 S5 User Manual page 134

Running the Getting Started Wizard
Corporate Network
Default Gateway
10.30.24.1
Figure 75: Interface Routing: Example 1
Example 2: Segments on the Same Subnet and Target on a Different Subnet
In the example below (see
faces, one for data and management traffic, and one for replication traffic:
The source ETERNUS CS800 management/data IP address and the source
●
ETERNUS CS800 replication IP address are on the same subnet (192.168.10.x). The
target ETERNUS CS800 IP address is on a different subnet (192.168.20.x)
To make sure the replication segment is used when communicating with the target
●
ETERNUS CS800, you must add a network route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify the following routing details for the replication
interface on the source ETERNUS CS800:
●
●
●
120
10.30.24.x subnet
Figure
Destination - Use the subnet of the target ETERNUS CS800 (192.168.20.0).
Dest Netmask - Use 255.255.255.0.
Dest Gateway - Use the IP address of the gateway (192.168.10.1).
Initial Configuration, Connecting with the Network
10.50.50.x subnet
10.20.20.x subnet
10.40.40.x subnet
76), the ETERNUS CS800 has two segmented inter-
Host or Client
10.50.50.1 gateway
10.20.20.1 gateway
10.40.40.1 gateway
Host or Client
U41840-J-Z125-7-76