Fujitsu ETERNUS CS800 S5 User Manual page 308

System
5. Select the check box for each type of network traffic allowed on the interface
(segmentation):
I
I
I
●
●
●
●
6. Click Update to save the changes you made to the IP Address table. (Clicking Update
does not yet apply the new network settings to the ETERNUS CS800.)
Click Delete to remove IP address information for the selected interface. Or click Undo
to revert all current IP Address Table changes to the last update.
I
Configuring Interface Routing
Some network configurations require that you specify routing details for an interface. You
need to specify routing details if the host or client the interface connects to is on a different
subnet. You also need to specify routing details if you have configured multiple network
segments (replication, data, or management) on the same subnet. For more information
and examples, see
294
At least one interface must allow management traffic.
If the ETERNUS CS800 is configured for source or target replication, you
should configure at least one interface to allow replication traffic (select Repl or
Any) before applying changes to network settings.
If you configure segmentation for non-bonded interfaces (Ethernet ports) that
are on the same subnet, all traffic will use the lowest numbered Ethernet port
first, no matter how segmentation is configured. To avoid this issue, create
bonded interfaces, and then select the desired traffic type for each bonded
interface.
Mgmt - Select to allow management traffic.
Repl - Select to allow replication traffic.
Data - Select to allow data traffic.
Any - Select to allow all types of traffic (management, replication, and data).
When you add a network interface, a default route (via the default gateway) is
automatically created for the interface after network settings are applied and the
ETERNUS CS800 reboots. For example, if you add an interface with IP address
10.20.185.172, a route with the destination IP address 10.20.185.0 is
automatically added. If you delete the default route, it is automatically added
again the next time network settings are applied and the ETERNUS CS800
reboots. For more information about interface routing, see Understanding
Interface Routing on page 362.
"Understanding Interface Routing" on page
Configuration
296.
U41840-J-Z125-7-76