Fujitsu ETERNUS CS800 S5 User Manual page 240

VTL
I
V
4. Select the check boxes for the media changer and tape drives to add to the host access
group.
The LUN assignment displays next to the device.
5. Click Apply.
Editing a Remote Host Access Group
Edit a host access group to change the CCL setting. You can also add or remove virtual
media changers or tape drives.
To edit a host access group:
1. Select the group and click Edit.
The Edit Remote Host Mapping page displays (see
I
226
The CCL (Command and Control LUN) is not used in most environments. This
option is recommended for host access groups that contain an HP-UX host. It
can also be used if hosts that are not assigned to any host access group exist
in the SAN. The CCL is accessible to hosts only through LUN 0.
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Customer Support
before you enable this option.
If you are editing a host access group, you cannot change the Group Name,
Partition, Remote Host, or Target.
Configuration
Figure 142).
U41840-J-Z125-7-76