Fujitsu ETERNUS CS800 S5 User Manual page 237

Configuration
Remote Host Mapping
The Remote Host Mapping page allows you to view information about existing host
access groups. You can also add or edit groups, and delete groups.
Host access groups allow backup hosts to access virtual devices on a ETERNUS CS800.
A host access group is associated with a partition, a host (a Fibre Channel initiator on the
SAN), and a target (a Fibre Channel port on the ETERNUS CS800). This association allows
the host to access one or more devices in the partition using different host LUNs on the port.
To allow multiple hosts to access devices that belong to the same partition, you must create
separate host access groups for each host.
To access the Remote Host Mapping page, on the Remote Host Access page, click the
Remote Host Mapping tab (see
Figure 140: Host Mapping Page
Use the Remote Host Mapping page to perform the following tasks:
View information about existing host access groups (see
●
Groups" on page
Add a new host access group to a partition (see
●
on page
Edit properties for an existing host access group (see
●
Group" on page
Delete a host access group from a partition (see
●
Group" on page
U41840-J-Z125-7-76
224).
224).
226).
228).
Figure 140).
"Adding a Remote Host Access Group"
"Deleting a Remote Host Access
"Remote Host Mapping And
"Editing a Remote Host Access
VTL
223