Table of Contents
Advertisement
Replication Wizard
b) (Optional) Select the Enable Cartridge based replication to target check box to
c) Select the check box for each replication target you want to replicate the partition
3. To configure the partition to receive replicated data from another system, enter the
following information under Receive:
a) (Optional) Select the Enable Cartridge based replication to this System check
b) If you enabled Cartridge Based Replication, select an Access option:
I
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
166
enable Cartridge Based Replication for the partition, and then enter a Sync ID in
the box.
With Cartridge Based Replication, a cartridge is automatically replicated when it is
unmounted. After replication, the replicated cartridges are immediately available on
the target system.
The Sync ID is used to identify the target partition that will receive replicated data
from the source partition. The Sync ID must be identical to the Sync ID of the target
partition on the target system.
to. When the partition is replicated, its data will be sent to all selected targets.
box to enable Cartridge Based Replication for the partition, and then enter a Sync
ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to
the target partition. The Sync ID must be identical to the Sync ID of the source
partition on the source system.
Locked - The partition is not allowed to receive new Cartridge Based Repli-
●
cation data.
Unlocked - The partition is allowed to receive new Cartridge Based Replication
●
data.
You cannot configure a partition to both send and receive Cartridge Based
Replication data.
Configuration Wizards
U41840-J-Z125-7-76
Hide quick links:
Advertisement
Table of Contents
