Replication Configuration
Replication Configuration
The Replication Configuration page allows you to configure and manage replication
targets and allowed replication sources on the ETERNUS CS800. A source
cated data to 1 or 2 targets, and a target
An ETERNUS CS800 can act as both a source and a target.
I
I
To access the Replication Configuration page, click the Configuration menu, and then
click the Replication tab (see
Figure 146: Replication Configuration Page
Use the Replication Configuration page to perform the following tasks:
View information about configured replication target systems (see
●
on page
Add, edit, or delete a replication target (see
●
"Editing a Replication Target" on page
page
232
For more information about data replication, or to perform data replication, see
"Replication" on page
If the ETERNUS CS800 is configured as a source and replication is performed
across a public network, with the source and target located behind NAT-enabled
routers, you must specify a NAT IP address for the ETERNUS CS800 on the
Network page (see
"Configuring Interface IP Addresses" on page
233).
237).
receives
341.
Figure
146).
"Adding a Replication Target" on page
235, or
"Deleting a Replication Target" on
replicated data from up to 10 sources.
"Target Systems List"
Configuration
sends
repli-
292).
234,
U41840-J-Z125-7-76