Step 5: Map Remote Hosts - Fujitsu ETERNUS CS800 S5 User Manual

Configuration Wizards

Step 5: Map Remote Hosts

1. Enter information about the host access group (see
●
●
●
●
I
2. (Optional) Select the Use CCL check box to use the Command and Control LUN.
I
V
3. Click Add.
4. (Optional) To map additional hosts, repeat Steps 1–3.
5. Click Next to continue.
U41840-J-Z125-7-76
Group Name - Enter a name for the group.
Partition - Select the partition to associate with the group.
Remote Host - Select the host (initiator) to associate with the group.
Target - Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system. A dark border
displays around the currently selected target.
To change the LUN numbers assigned to a device, or to map virtual devices to
a host, use the Configuration > VTL > Remote Host Access > Remote Host
Mapping page (see
The CCL (Command and Control LUN) is not used in most environments. This
option is recommended for host access groups that contain an HP-UX host. It
can also be used if hosts that are not assigned to any host access group exist
in the SAN. The CCL is accessible to hosts only through LUN 0.
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Customer Support
before you enable this option.
"Remote Host Mapping" on page
Figure 96):
223).
VTL Wizard
151