Table of Contents
Advertisement
ETERNUS CS800 S4/S5 Hardware
DX80 S2 Storage Subsystem
Hard Disk Drive Removal and Installation
The Hard Disk Drive (HDD) used in the storage modules is a 3.5'' NL-SAS HDD with
7200 rpm.
V
I
Removing
1. Press the latch of the HDD unit (see 1 in
Figure
Figure 301: Unlocking a 3.5-inch HDD Module
514
CAUTION!
In order to avoid giving damages to the device by the static electricity of human
body, be sure to wear a wrist strap during the maintenance work.
Hot Maintenance work should be finished within 5 minutes (for preventing temper-
ature rise).
This component can be replaced, during operation of the system (Hot
Maintenance). The component cannot be replaced when the system is powered off.
When replacing the HDD unit, it is possible that the error log will display multiple
errors, due to a temporary disarray of the transmission route within the
separation/connection of the HDD unit. This is not a problem/error of the HDD unit
or the device.
302).
Removal and Replacement Procedures for CRUs
Figure
301) and open the lock lever (2 in
U41840-J-Z125-7-76
Hide quick links:
Advertisement
Table of Contents
