Fujitsu ETERNUS CS800 S5 User Manual page 312

System
To make sure the replication segment is used when communicating with the target
●
ETERNUS CS800, you must add a network route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify the following routing details for the replication
interface on the source ETERNUS CS800:
●
●
●
In addition, to enable communication with the target ETERNUS CS800 by means of the
●
gateway, you must add a second host route in the Routing Details section on the
source ETERNUS CS800.
In this example, you would specify a second set of routing details for the replication
interface on the source ETERNUS CS800:
●
●
●
Source ETERNUS CS800
Replication IP:
192.168.10.100
Management/Data IP:
192.168.10.101
Figure 184: Interface Routing: Example 2
Backpanel Locations
The Backpanel Locations section at the bottom of the Network page displays a graphical
representation of the virtual Ethernet ports as they appear on the rear of the system.
The diagram indicates the current bonding configuration and connectivity status for all
Ethernet ports.
Ports that are bonded together in an interface are shaded the same color.
●
298
Destination - Use the subnet of the target ETERNUS CS800 (192.168.20.0).
Dest Netmask - Use 255.255.255.0.
Dest Gateway - Use the IP address of the gateway (192.168.10.1).
Destination - Use the IP address of the gateway (192.168.10.1).
Dest Netmask - Use 255.255.255.255.
Dest Gateway - Use the replication IP address of the source ETERNUS CS800
(192.168.10.100).
192.168.10.x subnet 192.168.20.x subnet
Gateway IP:
192.168.10.1
192.168.20.1
Configuration
Target ETERNUS CS800
IP: 192.168.20.200
U41840-J-Z125-7-76