Fujitsu ETERNUS CS800 S5 User Manual page 243

Configuration
I
To add a host:
1. Click Discover Remote Hosts to list all hosts that are know to the ETERNUS CS800
in the table.
A host is made known to the ETERNUS CS800 if you enter the host ID on this page, or
if the host logs on to one or more Fibre Channel target ports.
If you do not see the world wide port name (WWPN) of the host, make sure the host is
connected to a Fibre Channel port on the ETERNUS CS800 and click Discover
Remote Hosts again.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system.
2. Optionally enter a descriptive alias for the host(s).
3. Click Apply.
I
Targets
Use the Targets page to view the current target (Fibre Channel) configuration.
To access the Targets page, on the Host Access page, click the Targets tab (see
Figure 144).
Figure 144: Targets Page
U41840-J-Z125-7-76
A mapped (green) status indicates that a host is currently logged on to the
appropriate Fibre Channel target port.
To delete a host that is no longer needed, click Delete next to the host. You cannot
delete a host of it is currently assigned to a host access group.
VTL
229