Fujitsu ETERNUS CS800 S5 User Manual page 242

VTL
Deleting a Remote Host Access Group
Delete a host access group if it is no longer needed.
To delete a host access group:
1. Select the group and click Delete.
I
2. Click Yes to confirm the deletion.
Remote Hosts
Use the Remote Hosts page to discover and add Fibre Channel hosts to the available host
list for the ETERNUS CS800.
I
V
To access the Remote Hosts page, on the Remote Host Access page, click the Remote
Hosts tab (see
Figure 143: Remote Hosts
The Target Ports section displays a graphical representation of the Fibre Channel and
Ethernet ports as they appear on the rear of the system.
228
You can select multiple groups to delete at once.
You must configure a host before you can assign it to a new host access group (see
"Adding a Remote Host Access Group" on page
CAUTION!
If you are connecting the ETERNUS CS800 directly to a host without using a Fibre
Channel switch, you must know the WWPN connecting to each ETERNUS CS800
port. If you do not specify this information, the virtual medium changer and tape
drives will not display on the device manager.
Figure 143).
Configuration
224).
U41840-J-Z125-7-76