Fujitsu ETERNUS CS800 S5 User Manual page 141

Remote Management
Figure 80: Login Window
If the Login window does not display, verify that the IP address is correct and that the
network path to the ETERNUS CS800 is valid. Also verify that you are using a
supported Web browser and JavaScript is enabled. When using Microsoft Internet
Explorer, it may be helpful to add the IP address to the Trusted Sites Zone. Then try
again. If you are still unable to access the Login window, contact your ETERNUS
CS800 administrator.
I
3. Select the login type and enter the corresponding password.
●
●
I
4. Click Login.
5. If a security banner message has been specified for the ETERNUS CS800, click
Accept.
U41840-J-Z125-7-76
The default IP address is 10.1.1.1. The IP address can be changed during
installation using the Getting Started Wizard or at a later time on the Network
page (see "Network" on page
Monitor - Allowed to view information on the ETERNUS CS800 remote
management console but cannot make changes. (The default password is
password.)
Administrator - Allowed to view and change information on the ETERNUS CS800
remote management console. (The default password is spcc.)
Passwords are limited to 15 characters. All alphanumeric characters are
allowed, as well as underscores ( _ ) and hyphens ( - ). Passwords can be
changed on the Web & CLI Passwords page (see
page 301).
Accessing Remote Management
286).
"Web & CLI Passwords" on
127