Deleting A Replication Target; Pausing Or Resuming Replication To A Target; Enabling System Throttling - Fujitsu ETERNUS CS800 S5 User Manual

Configuration

Deleting a Replication Target

Delete a replication target if the ETERNUS CS800 no longer needs to send replicated data
to that target. After the target system is deleted, the ETERNUS CS800 will no longer send
replicated data to that system.
1. Under Target Systems, select one or more targets to delete.
2. Click Pause to pause replication to the target.
3. Click Delete.

Pausing or Resuming Replication to a Target

The source system controls the replication pause behavior.
To pause replication, select a target under Target systems and click Pause. The system
●
temporarily stops sending replicated data to the selected target.
To resume replication, select a target under Target systems and click Resume. The
●
system resumes sending replicated data to the selected target.

Enabling System Throttling

Enable system throttling to limit the network bandwidth used for replication to all targets.
When a constant throttle is enabled, the system limits the amount of data it sends during
source replication so that it does not exceed the specified bandwidth.
I
I
U41840-J-Z125-7-76
If multiple targets are configured, replication to all targets counts against the same
bandwidth limit.
To vary the replication throttle rate over time, use the Configuration > Scheduler
page (see "Scheduler" on page
schedule is configured. The scheduled replication throttling bandwidth settings take
precedence over the constant throttle value. (The currently active replication throttle
rate appears on the Home page under Current Activity.)
277). Do not enable a constant throttle if a throttle
Replication Configuration
237