Replacing The Ac Power Supply In Cisco Asr 1002 Router - Cisco ASR 1000 Series Installation And Configuration Manual

Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units
If you remove a power supply, the system can run for a maximum of five minutes before the system shuts
Caution
down. The fans and power elements are independent within the power supply. Therefore, it is not
required that the replacement power supply be energized within five minutes. The only requirement is
that the power supply be installed in the chassis, which energizes the fans and maintains proper system
cooling.
Step 4 Grasping the power supply handles, pull the power supply from the chassis.
Replace the AC power supply within five minutes.
Step 5
This completes the procedure for removing the AC power supply from the Cisco ASR1002 chassis.

Replacing the AC Power Supply in Cisco ASR 1002 Router

This section provides information about installing an AC power supply in the Cisco ASR 1002 Router.
Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050
Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.
Step 1
Tighten the captive screws.
Step 2
To connect AC power to the Cisco ASR 1002 Router, follow these steps:
At the rear of the router, check that the power switch is in the Off (O) position.
Step 1
Note
Insert the AC power cable into the AC power inlet and then turn On (I).
Step 2
To ensure that the AC power cord does not interfere with other cables or wires, dress the AC power cable
Step 3
in one of the following ways.
a.
OL-13208-03
Turn the power switch to the On (I) position after both power sides of the power cord are
connected.
Leave a small service loop in the AC power cord from the inlet and then secure the power cord
through the AC power supply handle as shown in
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
Removing and Replacing a Cisco ASR 1002 Router Power Supply
Figure 8-30. Or go to step 3b.
8-41