Replace A Power Supply In A Cisco Asr 1013 Router; Remove And Then Replace An Ac Power Supply - Cisco ASR 1013 Quick Start Manual

Remove any power cables from the Cisco ASR 1013 Router.
Step 5
a. For power supplies with a circuit breaker switch, position the switch to the Off (O) position.
b. For power supplies with a Standby switch, place the Standby switch in the Standby position.
After powering off the router, wait a minimum of 30 seconds before powering it on again.
Note

Replace a Power Supply in a Cisco ASR 1013 Router

This section provides instructions for removing and replacing the AC power supply and the DC power supply in a Cisco
ASR 1013 Router. Before you begin, make certain the chassis is grounded.

Remove and Then Replace an AC Power Supply

To remove a live Cisco ASR 1013 Router AC power supply that is not operating normally (and then replace the AC power supply
within five minutes), follow this procedure:
Slip on the ESD-preventative wrist strap that was included in the accessory kit.
Step 1
Before you turn off a power supply, make certain the chassis is grounded.
Step 2
Turn the power supply Standby switch to the Standby position.of the power supply.
Step 3
Unplug the power cable from the AC inlet on the back of the power supply and the power source.
Step 4
Step 5 Unscrew the power supply captive screws.
Four power supplies must be installed in the chassis at all times, with a minimum of two power supplies (one per zone)
Note
connected to the mains in order to power on the system and ensure sufficient cooling. The system fans are inside the
power supply units and must spin for cooling. Because all the system fans can be powered by one power supply, the
second power supply unit does not have to be powered on, but must be connected.
If you remove a power supply from a system that has four power supplies that are connected and powered on, the
Caution
system can run only for a maximum of five minutes before shutting down. However, because the fans and power
elements are independent within the power supply, the replacement power supply does not have to be energized
within five minutes. The only requirement is that the power supply be installed in the chassis in order to energize
the fans and maintain proper system cooling.
Step 6 Grasping the power supply handles, pull the power supply from the chassis. When you remove the AC power supply,
you will see the following type of messages in the log report:
13ru_perf2#show log
Syslog logging: enabled (0 messages dropped, 6 messages rate-limited, 0 flushes, 0 overruns, xml
disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
Console logging: disabled
Monitor logging: level debugging, 0 messages logged, xml disabled,
filtering disabled
29