Uploading/Downloading Nvram Data - Ricoh M160 Service Manual

Uploading/Downloading NVRAM Data

5.3 UPLOADING/DOWNLOADING NVRAM DATA
5.3.1 UPLOADING CONTENT OF NVRAM TO AN SD CARD
Do the following procedure to upload SP code settings from NVRAM to an SD card.

All data that is stored in NV-RAM of the engine and controller is subject to update.

This data should always be uploaded to an SD card before the NVRAM is replaced.

Make sure that the write protection of an SD card is unlocked
1. Do SP5990 (SMC Print) before you switch the machine off. You will need a record of the
NVRAM settings if the upload fails.
2. Turn the machine main power switch off.
3. Remove the SD slot cover [A] (
4. Insert the SD card into SD card slot [B].
5. Then turn the machine on.
6. Execute SP5-824-001 (NVRAM Data Upload) and then press the "Execute" key.
7. The following files are copied to an NVRAM folder on the SD card when the upload
procedure is finished. The file is saved to the following path and filename:
NVRAM <serial number>.NV
Here is an example with Serial Number "K5000017114":
NVRAM K5000017114.NV
8. In order to prevent an error during the download, be sure to mark the SD card that
holds the uploaded data with the number of the machine from which the data was
uploaded.

You can upload NVRAM data from more than one machine to the same SD card.
M160/M161
x 1)
5-14 SM