Hdd Encryption - Ricoh M160 Service Manual

Icon [1]
Icon [2]

2.20.3 HDD ENCRYPTION

Before You Begin the Procedure:
1. Make sure that the following settings (1) to (3) are not at the factory default settings.
(1) Supervisor login password
(2) Administrator login name
(3) Administrator login password
These settings must be set up by the customer before the HDD Encryption unit can be
installed.
2. Make sure that "Machine Management" is on.
[User Tools/Counter] key -> [System Settings] -> [Administrator Tools] -> [Administrator
Authentication Management] -> [Machine Management] -> [On]
If this setting is off, tell the customer this setting must be on before you do the installation
procedure.
3. Make sure that "Administrator Tools" is enabled (selected).
[User Tools/Counter] key -> [System Settings] -> [Administrator Tools] -> [Administrator
Authentication Management] -> [Machine Management] -> [On] -> [Select available settings]
-> [Administrator Tools]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before you do the installation procedure.
Installation Procedure
1. Turn on the main power switch, and then enter the SP mode.
2. Select SP5878-002, and then press "Execute" on the LCD.
3. Exit the SP mode after "Completed" is displayed on the LCD.
4. Turn off the main power switch.
SM
This icon is lit when there is temporary data to be
overwritten, and blinks during overwriting.
This icon is lit when there is no temporary data to be
overwritten.
2-75
Security Settings
M160/M161