Ricoh M160 Service Manual page 662

FCU

The volume of the beep is set to the same level as the speaker volume.

If the speaker volume is set to off, the volume of the beep is set to its initial
factory-set level.

If the machine does not beep, switch the main power off and then back on and try the
data transfer again. Try several times if necessary.

Be sure to check the transfer result after executing data transfer. If the transfer has
failed, you need to specify settings manually in the SP mode.
13. When the message "Ready" appears on the control panel, switch the power off, and
then remove the AC power plug from the receptacle.
14. Disconnect the flat cable from both FCU boards.
15. Reattach the covers.
16. Turn the main power switch on.
17. Enter the SP mode, print the system parameter list from SP6-101 in the Fax SP menu,
and then check the list to see whether the SRAM data has been transferred correctly.
SM 6 M160/M161 Fax Option