Bit Switches - 6; Ip Fax Switches - Ricoh M160 Service Manual

4.7 BIT SWITCHES - 6


Do not adjust a bit switch or use a setting that is described as "Not used", as this may
cause the machine to malfunction or to operate in a manner that is not accepted by local
regulations. Such bits are for use only in other areas, such as Japan.
Default settings for bit switches are not listed in this manual. Refer to the System Parameter List
printed by the machine.

4.7.1 IP FAX SWITCHES

No Function
IP Fax Transport
1
0: TCP, 1: UDP
IP Fax single port selection
2
0: OFF, 1: ON (enable)
IP Fax double ports (single data
3 port) selection
0: OFF, 1: ON (enable)
IP Fax Gatekeeper
4
0: OFF, 1: ON (enable)
IP Fax T30 bit signal reverse
5
0: LSB first, 1: MSB first
IP Fax max bit rate setting
6
0: Not affected, 1: Affected
M160/M161 Fax Option
IP Fax Switch 00 (SP No. 1-111-001)
Selects TCP or UDP protocol for IP-Fax
Selects single data port.
Selects whether IP-Fax uses a double port.
Enables/disables the gatekeeper for
IP-Fax.
Reverses the T30 bit signal.
When "0" is selected, the max bit rate does
not affect the value of the DIS/DCS.
When "1" is selected, the max bit rate
affects the value of the DIS/DCS.
99
Bit Switches - 6
Comments
SM